Subject:
|
Re: 2 Motors -> 1 axle
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sat, 8 Jan 2000 18:25:34 GMT
|
Reply-To:
|
MATTDM@MATTDMnomorespam.ORG
|
Viewed:
|
776 times
|
| |
|
|
Andy Gombos <lego-robotics@crynwr.com> wrote:
> current was shared between 2 motors. I guess if you are running at speed
> four, and you hook up 2 motors, you could set the speed at 8 and get the
> same speed(correct me if I'm wrong).
Probably wrong, since the different speeds are done via pulse modulation.
--
Matthew Miller ---> mattdm@mattdm.org
Quotes 'R' Us ---> http://quotes-r-us.org/
|
|
Message is in Reply To:
 | | Re: 2 Motors -> 1 axle
|
| I had 2 motors hooked up to 2 outputs for valves. The valves ran fine. When I combined the 2 wires on one input, the valves ran considerably slower, since the current was shared between 2 motors. I guess if you are running at speed four, and you (...) (25 years ago, 8-Jan-00, to lugnet.robotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
