Subject:
|
Re: nqc -firmware
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 28 Dec 1999 18:14:56 GMT
|
Original-From:
|
Tim Gion <tcg3j@STOPSPAMMERScs.virginia.edu>
|
Viewed:
|
2493 times
|
| |
|
|
On Tue, 28 Dec 1999, rmemory wrote:
> The dos prompt gave the status dots (".....") to say it was downloading,
> and the LCD on the RCX showed the usual counting numbers (0 to 1500).
> But then for some reason, halfway or more through the download, the
> prompt would come back and say "No reply from the RCX" and the download
> would fail. I tried a couple more times and watched the numbers on the
I've had some problems with this with an older version of nqc. If you
give it a timeout of 70 or more (I believe), this should fix your problem.
I believe the flag is -timeout or -t.
Tim
Tim Gion
tcg3j@cs.virginia.edu (fastest) or gion@cs.virginia.edu
http://www.cs.virginia.edu/~tcg3j
|
|
Message is in Reply To:
 | | nqc -firmware
|
| Hi All, Last weekend, I finally had some spare time and took the opportunity to program my RCX with NQC. Sure beats the heck out the RCX code! However, I had some problems downloading the firmware before I could download my code. I used the (...) (27 years ago, 28-Dec-99, to lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
