Subject:
|
Re: "Caster Wheel" design ideas??
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 16 Dec 1999 03:21:04 GMT
|
Viewed:
|
600 times
|
| |
|
|
Try this for a castor. They are a little boxy, but it works.
Small turntable square with a 2*4 with 2 1*2 with hole on each end of the
2*4
Parts:
1 - small turntable
1 - 2*4 plate
2 - 1*2 solid
2 - 1*2 with hole
1 - 4 axle
2 - locks / micro pulleys
1 - small wheel
Mount 2*4 plate centred on the turntable with the solid 1*2 at each end of
the plate.
mount the 1*2 with holes on top of their solid mates
Put wheel between 1*2 stack, hold with axle put axle through hole followed
by a micro pulley on each end of axle
Terry King <tking@together.net> wrote in message
news:MPG.12c1d76a6ac971a79896c1@lugnet.com...
> Anyone got a good "caster wheel" design from MindStorms
> parts?
>
> I was working with some kids today, and didn't come up
> with anything workable... Using a skidpad for now....
>
> --
> Regards,
> Terry King ...In The Woods In Vermont
|
|
Message is in Reply To:
 | | "Caster Wheel" design ideas??
|
| Anyone got a good "caster wheel" design from MindStorms parts? I was working with some kids today, and didn't come up with anything workable... Using a skidpad for now.... (25 years ago, 15-Dec-99, to lugnet.robotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
