To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 9068
    Re: RCX Output —Joel Shafer
   So if you need a 1, 1.5 & 2ms pulse for controlling a servo and you said the low setting in NQC = a 1ms pulse, are there other matching motor speed settings to get a 1.5 or 2ms pulse? (...) Joel Shafer joel@connect.net (25 years ago, 15-Dec-99, to lugnet.robotics)
   
        Re: RCX Output —Nick Taylor
     Hello Joel, Attempting to drive an RC servo directly from the RCX is NOT a good idea! The servo is a three wire device; +4.8V to +6.0V for power (usually the red wire), an approximately 40Hz pulse train of 1.0 to 2.0ms pulses at 0V and +5V logic (...) (25 years ago, 15-Dec-99, to lugnet.robotics)
   
        Re: RCX Output —Dave Baum
   (...) The pulses are 1ms, 2ms, 3ms....7ms, 8ms. The 8ms case is sort of a degenerate case since the period itself is 8ms, so an 8ms pulse winds up being continuous power. Dave Baum (25 years ago, 16-Dec-99, to lugnet.robotics)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR