To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 8704
  RE: Tilt
 
The rotation sensor does seem like a very good way to go. The only real problem is you can only detect tilt on one plane (front to back, or side to side, not both) Unless, of course, you have two rotation sensors. (I didn't even bother ordering just (...) (25 years ago, 1-Dec-99, to lugnet.robotics)
 
  Re: Tilt
 
I'm surprised no one has mentioned this one yet. This is a way to get two axis tilt sensors. It is basically tilted or not, no graduating scale, but, see below later... Get an old Bic ball-point pen. Cut two cylinders to some arbitrary length. Bend (...) (25 years ago, 1-Dec-99, to lugnet.robotics)
 
  Re: Tilt
 
I tested the touch sensor approach...I think it will take too much weight/force to trigger the touch sensor. I'm now working on using the Mindstorms light sensor as a tilt sensor. I hung a freely swinging brick flush against the light sensor. As the (...) (25 years ago, 2-Dec-99, to lugnet.robotics)
 
  Re: Tilt
 
(...) [snip] (...) direction. What about inverting the problem? You could have a vertical shaft with a weight at the top, and some sort of resistance at the bottom (rubber bands? elastic strips?). Something like this: _____ | | | | <- weight ----- | (...) (25 years ago, 2-Dec-99, to lugnet.robotics)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR