Subject:
|
Re: IR tower question
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 18 Nov 1999 09:29:38 GMT
|
Viewed:
|
610 times
|
| |
|
|
I realize that the signal sent is 38 kHz at 2400 baud but isn't that set
by the serial port?
Robert Eddings
|
|
Message has 1 Reply:
 | | Re: IR tower question
|
| Robert, I hope an electronics person tells me I'm wrong, because this is where I'm stuck too. The serial port sets 2400 baud. But my understanding is that we have to get the Palm to generate a 38kHz signal. That is, pulse the IR led on/off at 38kHz. (...) (25 years ago, 18-Nov-99, to lugnet.robotics)
|
Message is in Reply To:
| | RE: IR tower question
|
| I stripped my IR tower few days ago and draw a partial schematics out of it. TX side. There are two IR diodes connected series. Low power level feed is 100 ohm and high level is 5.6 ohms. Low range diode current is somewhere around 50 mA. I have not (...) (25 years ago, 18-Nov-99, to lugnet.robotics)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
