To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 8121
  Re: Homemade LED Bricks
 
Keith Miller writes: > basicly.. it's i*r=v where i = current in amps and r = resistance in ohms > and v = voltage in volts.. > so.. > If we want to find out the resistor's value.. we re arrange it like so.. > r = v/i > so 10 millamps (typical led (...) (25 years ago, 12-Nov-99, to lugnet.robotics)
 
  Re: Homemade LED Bricks
 
Russell Nelson <lego-robotics@crynwr.com> wrote in message news:14380.1027.3890...nwr.com... (...) Its not .7 volts for an LED its more like 1.8volts and its takes 20ma if you want for full brightness for a typical display LED. (or more for a (...) (25 years ago, 12-Nov-99, to lugnet.robotics)
 
  Re: Homemade LED Bricks
 
(...) The forward voltage of the LED does depend on the colour. In an electronics catalogue, the following values are listed, but do vary for specific devices. Red typically 2v Yellow 2.1v Green 2.2v Blue 3.3v White 3.6v ///// < .. > > - (...) (25 years ago, 12-Nov-99, to lugnet.robotics)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR