 | | Re: multiplexed touch sensors [was: Re ideas for a RIS 2.0]
|
|
(...) I don't doubt that there are reasonable creations that e.g. press a touch sensor button halfway for extended periods of time, but I can't think of any off the top of my head. Can anybody help me out here? My point was that in what I would (...) (27 years ago, 26-Aug-99, to lugnet.robotics)
|
| |
 | | Re: multiplexed touch sensors [was: Re ideas for a RIS 2.0] [DAT]
|
|
(...) Okay, I felt like I had some time, so I looked into this a bit. I skipped the first part and jumped right into measuring a waveform. I measured a faster waveforms for now, but might give it another go with a longer waveforms and higher (...) (27 years ago, 26-Aug-99, to lugnet.robotics)
|
| |
 | | RE: Touch Sensor as a Switch
|
|
In response to my own post on the Cybermaster touch sensors: The three different Cybermaster touch sensors have a resistance of 15k, 12k, and 10k when not pressed. The rest of my ramblings were pure fiction. The three Cybermaster inputs are (...) (27 years ago, 26-Aug-99, to lugnet.robotics)
|
| |
 | | Re: robotic rovers
|
|
(...) Have you tried combining the inputs of the two output motors into a differential? If the inputs are counter-rotating, the net differential body rotation will tell you which side is moving faster, ie: Motor A ------> Differential <--(Reversed (...) (27 years ago, 26-Aug-99, to lugnet.robotics)
|
| |
 | | Use a RCX as a Sensor port AND a Motor Output!
|
|
So, I was messing around w/ the RCX and hooked up a Micromotor to one of my output ports and lo and behold....I could control the motor by toggling the Sensor Type for that port between a Passive (None, Switch, Temp) mode = OFF and an Active Mode (...) (27 years ago, 26-Aug-99, to lugnet.robotics)
|