To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 5321 (-5)
  Wheel Setup for the 8880
 
Has anyone came up with a good way to use the wheel assemblies that come with the 8880 with smaller tires (the 68.8 x 40 Q)? -- Clay Aucoin (27 years ago, 12-Jun-99, to lugnet.robotics)
 
  GORDON'S BRICK PROGRAMMER
 
Just wandering if any one was using GBP? (27 years ago, 12-Jun-99, to lugnet.robotics)
 
  Thanks ...Re: Removing red led from light sensor..
 
Thanks for all the advice. I got the parts from radio shack and just made a new light sensor today. Now its time to start working with NQC or GORDON'S BRICK PROGRAMMER or somthing. Patrick Lawrence wrote in message ... (...) (27 years ago, 12-Jun-99, to lugnet.robotics)
 
  adam@hpnc.com
 
I went to helitex today and they has sent out a check yesterday by mail. I should get it monday I think. Also Gary said that it is still not emailing him the orders. Didnt you say you changed the email address to heli212@waymark.net Could you please (...) (27 years ago, 12-Jun-99, to lugnet.robotics)
 
  Re: micro motor sometimes stuck
 
(...) The slippage is supposed to occur between the micro motor and the pulley, not the pulley and the axle. The micro motor uses a stud (rather than an axle) as its output, and you insert that stud into the rubber lining. Cheers, Hao-yang Wang (27 years ago, 11-Jun-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR