Subject:
|
Re: micro motor sometimes stuck
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 11 Jun 1999 10:11:47 GMT
|
Viewed:
|
1147 times
|
| |
|
|
The micro motor doesn't have an axle output, just a standard stud.
David Kadansky wrote in message <3760AC13.5079426F@pobox.com>...
> Wow. I never noticed the rubber in those pulleys before.
>
> So you insert the axle just far enough to engage only the rubber lining?
> It seems that if you put the axle all the way through there is no slippage.
|
|
Message is in Reply To:
 | | Re: micro motor sometimes stuck
|
| Wow. I never noticed the rubber in those pulleys before. So you insert the axle just far enough to engage only the rubber lining? It seems that if you put the axle all the way through there is no slippage. (...) -- Did you check the web site first?: (...) (25 years ago, 11-Jun-99, to lugnet.robotics)
|
7 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
