 | | Re: moving in a straight line with two motors?
|
|
Tim, Instead of using the differential for angle sensors, why not use it to allow a single motor to drive both wheels? Then a single angle sensor coupled with a motor could drive the steering mechanism. This setup would be very similar to a radio (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
(...) At one point, in the distant past, I saw plans for a gear box that used either 2 or 3 differentials, I do not remember which. 2 motors were used, 1 to drive both axles, one for steering. axle1 == motor1 + motor2 axle2 == motor1 - motor2 With (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
|
| |
 | | Direct Motor driver
|
|
Thanks to the fine people who figured the memory mapped motor I/O address to be 0xf000 and who determined the controlling bitmaps, I wrote a native motor driver today. See (URL) missing for a V0.1 kernel release: - task switcher IRQ reassignment (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
|
| |
 | | RE: moving in a straight line with two motors?
|
|
-----Original Message----- From: Eric Brandwine [SMTP:ericb@mitre.org] Sent: Friday, November 13, 1998 8:39 AM To: John Scott Kjellman Cc: lego-robotics@crynwr.com Subject: Re: moving in a straight line with two motors? <snip> (...) I don't think it (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
From: John Scott Kjellman <jkjellman@ameritech.net> (...) The main downside with this approach is that you can't turn on axis (so your vehicle will no longer have a turning radius of 0). When I first got the mindstorms I thought that it would be (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
|