Subject:
|
Re: More Output ports!
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 7 Mar 1999 23:47:12 GMT
|
Viewed:
|
1016 times
|
| |
|
|
I would be interested in seeing what you have done.
How do you control the switch, with the third RCX output ?
--
SeeYa !
------------
Jim
----------------------------------------------------------------------------
Hello... Is this thing on ?
John Brubaker wrote in message <36e2aace.12707929@lugnet.com>...
> Hi All - I posed a question a couple of weeks back about using small
> relays to switch control of outputs in order to use more motors.
> My robot uses 2 powered treads for forward, reverse, and turn. The
> gripping arm uses a motor to raise and lower, then another motor
> controls a pneumatic switch to open or close the claw using a small
> air cylinder. It all works quite well. If anyone's interested in the
> switching device, I'll post some pictures of it this week. It fits
> into a Lego brick 2 pegs x 6 pegs x 6 thick. Regards --- John.
|
|
Message has 1 Reply:
Message is in Reply To:
 | | More Output ports!
|
| Hi All - I posed a question a couple of weeks back about using small relays to switch control of outputs in order to use more motors. Since nobody said they had done it, I went ahead and bought some parts from Radio Shack, and built a small (...) (26 years ago, 7-Mar-99, to lugnet.robotics)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
