 | | Re: Robotics sub-groups
|
|
(...) Well, I want the resolution that's most beneficial to the individual projects and most enjoyable for participants. Fine resolution is good as long as it lives up to the promise of providing for more focused discussions but bad if it is so fine (...) (28 years ago, 14-Feb-99, to lugnet.admin.general, lugnet.robotics)
|
| |
 | | RCX Assembler programing
|
|
I'm using the RCX together with the Spirit OCX and VB 5. But it seems to me as the Spirit OCX has the comfort of machine language and the flexibility of standard basic. So I would like to have a more powerful and flexible tool for the programming ( (...) (28 years ago, 14-Feb-99, to lugnet.robotics)
|
| |
 | | Re: An untested idea...
|
|
This sounds like an old Lionel(sp?) train's forward-neutral-reverse switch. Anders Isaksson wrote in message ... (...) (28 years ago, 14-Feb-99, to lugnet.robotics)
|
| |
 | | Sensors
|
|
I am gathering parts to make sensors and was wondering if anyone has a good source for small microswitches ( for tuch sensors) and also LED lights 9 to 12 volt. Thanks in Advance Jim Clark ---...--- This message was sent from Bess.Net, a filtered (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Sensors
|
|
I found every thing I needed as far as the light sensors at Radio Shack. I don't know where you're located, but here in California, Fry's Electronics is the place to go. You can get everything you need from parts, boards, and the junk food to eat (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Sensors
|
|
The best source I can think of is the old family VCR. It has MANY momentary switches and probably 5 or more LED's in the front panel. There are two infra-red photosensors and a two sided infra-red LED on a post in the tape drive area. Good Luck! :-> (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Robotics sub-groups
|
|
(...) I agree with your gut- go with one group at first. I suspect it will be a relatively quiet group anyway. Dave (28 years ago, 15-Feb-99, to lugnet.admin.general, lugnet.robotics)
|
| |
 | | Re: RCX Assembler programing
|
|
Actually, you'll need a Hitachi H8 assembler. I think there is reasonable support for Hitachi H8 in the gnu assembler. Unfortunately I can't remember if the assembler is in its own distribution package, or part of binutils. Dave (...) reply to: (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Sensors
|
|
(...) I found a GREAT source for small switches is inside an old mouse (um, computer mouse, NOT the rodent). I took apart several different brands of mice, and while they had different ways to measure movement, they all used the same type of (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
|
| |
 | | Re: RCX Assembler programing
|
|
=>From: dbaum@spambgoneenteract.com (Dave Baum) =>... =>Actually, you'll need a Hitachi H8 assembler. I think there is reasonable =>support for Hitachi H8 in the gnu assembler. Unfortunately I can't =>remember if the assembler is in its own (...) (28 years ago, 15-Feb-99, to lugnet.robotics)
|