To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 3021 (+5)
  Sensor monitoring
 
I have a project that I am building, it is a finish line monitor for a pinewood derby track. What I am doing is putting two light sensors above the track pointing down so the ambient light will change when the car crosses the finish line. One sensor (...) (28 years ago, 20-Jan-99, to lugnet.robotics)
 
  Re: Sensor monitoring
 
To my knowledge the LEGO firmware executes one instruction at a time for each task, so there is one and only one instruction being executed at a certain instant even if you have multiple tasks. Because NQC uses the LEGO firmware, I don't think you (...) (28 years ago, 20-Jan-99, to lugnet.robotics)
 
  Re: Voltage generator
 
In article <Pine.GSO.3.96.99012....uen.org>, jeff <jeff@uen.org> writes (...) Wait for a calm day and mount it 3 ft above a car, or on the front of a bike with a speedometer. Make several runs in opposite directions at constant speed and take the (...) (28 years ago, 20-Jan-99, to lugnet.robotics)
 
  Re: Dacta in Canada? (Was Re: Differentials also available from LegoDacta)
 
The catalog from Spectrum that I have seen has all the Technic related Dacta Service Packs. (...) of (...) I can clear up the "unlikely" scenario that you mentioned. if you tell me what you are looking for, I will just look in the catalog and tell (...) (28 years ago, 20-Jan-99, to lugnet.robotics)
 
  Re: Voltage generator/Anemometer
 
In article <Pine.GSO.3.96.99012....uen.org>, jeff <jeff@uen.org> writes (...) Measuring the voltage would be more accurate. (28 years ago, 20-Jan-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR