 | | Re: Synchro drive in Lego
|
|
(...) Hi, I'm new here, so if I'm missing something, sorry! Seems what you are describing is just what I'd call a "relay switch". The output signal from the RCX goes to a switch, which switches the external power going to your motors. Seems to me (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Synchro drive in Lego
|
|
(...) Hrm... how would you manage that? I cannot think of any purely mechanical approach that could do the trick. (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
|
| |
 | | Re: Pen Mounting Ideas?
|
|
(...) If you construct a beam with an L-shaped cross section, the pen can rest along the groove in the corner of the L, held with small rubber bands at top and bottom. (...) Try putting the tires on the end of a hinged beam, so that they can provide (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
|
| |
 | | Re: RCX 2.0 -- ideas.
|
|
(...) Brett, I have been working on a couple different transmission designs with multiple gear ratios. I am most interested in knowing how you used a RCX motor to shift the motors into the two different drive trains. Does it require any sensors? Any (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
|
| |
 | | Re: simple but functional radar
|
|
(...) Chris, I built a little RadarBot just like yours (very minimalist, I love it :) and wrote some NQC code to drive it around my kitchen floor. It really zooms, until the left wheel inevitably falls off. :) The program below might help you get (...) (28 years ago, 14-Jan-99, to lugnet.robotics)
|