 | | Re: Ordering custom-cut plastic gears for Legos
|
|
(...) One problem is that changing teeth number also change gear diameter... and you will run into some troubles with LEGO grids. Philo (16 years ago, 29-Sep-08, to lugnet.robotics)
|
| |
| | Re: Slope Brick 1x1
|
|
(...) ...but if you look at the overall slope of the part, it is closer to 38 degrees. Philo (16 years ago, 29-Sep-08, to lugnet.robotics)
|
| |
| | Re: Slope Brick 1x1
|
|
(...) So what name do we give this piece? Slopebrick 33, 45 or rather 38? (16 years ago, 29-Sep-08, to lugnet.robotics)
|
| |
| | Re: need to make a 15 degree angle
|
|
(...) It doesn't need to be exact, just repeatable. I need to make an armature of 4 or 5 successive 15degree "turns" to support some panels that are making sort of a jointed arc. I'll give the technic pieces a try. Almost jumped for joy at Nick (...) (16 years ago, 1-Oct-08, to lugnet.robotics)
|
| |
| | Re: need to make a 15 degree angle
|
|
(...) Further measurements show that connector #3 is 22.5 degrees - this means you can use these to make a jointed 90 degree arc with 5 panels (the ends would be perpendicular to each other). Would this meet your design requirement? (16 years ago, 2-Oct-08, to lugnet.robotics)
|
