Robotics : 27095


Robotics / 27095	27094 \| 27096

Subject:	Re: Control Lab & NQC
Newsgroups:	lugnet.robotics
Date:	Mon, 7 May 2007 16:20:58 GMT
Viewed:	4286 times

linmix wrote: > I was looking for references to the Control Lab in Lugnet and came > across this post > (http://news.lugnet.com/market/buy-sell-trade/?n=16650) by John > Hansen trying to buy a Control Lab to add some support for in in > BricxCC/NQC. Is that the same as the Dacta 70909? I have a page with some info about that and its protocol, and a test environment programmed (with a puny 'programming language') in Delphi - no OCX needed. Source is available. http://web.telia.com/~u16122508/dacta/ -- Anders Isaksson, Sweden BlockCAD: http://web.telia.com/~u16122508/proglego.htm Gallery: http://web.telia.com/~u16122508/gallery/index.htm

Message has 2 Replies:

		Re: Control Lab & NQC
(...) that's the one. Thanks for the link. I'll certainly try it out. (18 years ago, 7-May-07, to lugnet.robotics)

		Re: Control Lab & NQC
(...) someone still has an information page up. (18 years ago, 8-May-07, to lugnet.robotics)

Message is in Reply To:

		Control Lab & NQC
I was looking for references to the Control Lab in Lugnet and came across this post ((URL) by John Hansen trying to buy a Control Lab to add some support for in in BricxCC/NQC. I can't seem to find out if anything ever came of it. Can anyone tell (...) (18 years ago, 6-May-07, to lugnet.robotics)

8 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Active threads in Robotics

	Contact Recovery Nerd for Speedy USDT / BTC Recovery 22 hours ago

Custom Search