 | | Re: Bricx Command Centre and the NXT
|
|
(...) BricxCC uses the NXT Fantom API layer to communicate with the NXT via both bluetooth and USB. If you have the NXT Fantom drivers installed properly (which, if you can communicate with the NXT via the standard NXT software, you must) then when (...) (18 years ago, 15-Mar-07, to lugnet.robotics)
|
| |
| | Re: BricxCC release 3.3.7.16
|
|
(...) Please respond with detailed information regarding your configuration. Are you using the serial tower or are you using the USB tower? Do you have the firmware already installed on your RCX brick? What does the LCD screen look like when your (...) (18 years ago, 15-Mar-07, to lugnet.robotics)
|
| |
| | Re: Where to find troubleshooting guide for installing the NXT Fantom
|
|
(...) There is a link to it in the NXT News section of the main BricxCC page. (URL) Hansen (18 years ago, 15-Mar-07, to lugnet.robotics)
|
| |
| | Where to find troubleshooting guide for installing the NXT Fantom
|
|
Dear All, I found this text on the forum about the Bricx Command Centre "I put together a short troubleshooting guide for installing the NXT Fantom Drivers on a windows box" Wher can I find this? Regards Jan Kromhout Hellevoetsluis-NL (18 years ago, 15-Mar-07, to lugnet.robotics)
|
| |
| | Re: BricxCC release 3.3.7.16
|
|
There are several possible reasons for your problem(s). * Is COM1 the right port? If it isn't just before the main window of BricxCC is opened you are informed communication with the brick was unsuccessful and that you'll not be able to download (...) (18 years ago, 15-Mar-07, to lugnet.robotics)
|
