Subject:
|
Re: Power Functions Element Pics (inc Plugs)
|
Newsgroups:
|
lugnet.technic, lugnet.robotics
|
Date:
|
Wed, 28 Feb 2007 23:16:09 GMT
|
Viewed:
|
1912 times
|
| |
|
|
In lugnet.technic, Mark Bellis wrote:
>
> OK, here's a few while you wait :-)
>
> Basic system as used in the creator dinosaur set 4958 (inc handset & battery
> box):
> http://www.brickshelf.com/gallery/mbellis/Technic/Power-Functions/pf_basic_system_for_dinosaur.jpg
>
> RC IR receiver:
> http://www.brickshelf.com/gallery/mbellis/Technic/Power-Functions/pf_ir_rx_front.jpg
> http://www.brickshelf.com/gallery/mbellis/Technic/Power-Functions/pf_ir_rx_rear.jpg
>
> Large motor (inc plug top):
> http://www.brickshelf.com/gallery/mbellis/Technic/Power-Functions/pf_large_motor.jpg
>
> Medium motor (inc stud recesses on bottom and plug bottom):
> http://www.brickshelf.com/gallery/mbellis/Technic/Power-Functions/pf_medium_motor.jpg
> http://www.brickshelf.com/gallery/mbellis/Technic/Power-Functions/pf_medium_motor_bottom.jpg
>
> Mark
Man, I'm excited. A few design flaws I can't understand though:
Why the cable nub coming out of the cable's brick? There has to have been a way
to avoid that.
On the large motor, why all that wasted space on the drkGry part that could have
pin holes? Also, I wouldn't say no to a wege-belt wheel pin-hole layout, for
the half-stud offset. Other than that, it looks good :D
On the small motor, it seems you would always need the pins on the front for a
strong connection, but oh well.
Looks good!
--Peter
|
|
Message is in Reply To:
27 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
