 | | Re: Working around the 3 output limitation —Brett Carver
|
| | | (...) I've got an working design that SEEMS to get around the problem of cumulative error. I use a gear plate that sits atop a regular gear. Since it's held in place by gravity, when it hits the limit of travel it simply slips. This allows me to (...) (26 years ago, 7-Jan-99, to lugnet.robotics)
|
| | | |
| | | | | Re: Working around the 3 output limitation —Ian Sinclair
|
| | | | (...) Brett, I don't follow this... What is a gear plate? Do you have any pics available? <ICS> -- Did you check the web site first?: (URL) (26 years ago, 14-Jan-99, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Working around the 3 output limitation —Brett Carver
|
| | | | (...) I know, and I'm sorry I can't seem to explain it with words. (...) Probably not the "official" term for it. It's a 1x4 plate with teeth on one side used to convert rotational motion (from a gear) to linear motion. I use it to move my shifting (...) (26 years ago, 15-Jan-99, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Working around the 3 output limitation —Jasper Janssen
|
| | | | (...) The one with two studs in the middle, and two holes at the ends? and you then have one of the half-bushings with teething (1) thaty it rests on? I would say that those teehings are too deep too slip comfortably, but I haven't tried it out. (1) (...) (26 years ago, 23-Jan-99, to lugnet.robotics)
|
| | | | |
