 | | Re: Pinball INFO - passed on from builder —Brian Davis
|
| | | (...) And it is really impressive! Wonderful job, and a very nice write-up. A few questions: (...) Neat solution. I was wondering how you networked between the two IR communication chambers (the article is a little vague, refering to a "direct (...) (19 years ago, 7-Nov-05, to lugnet.robotics)
|
| | | |
| | | | | Re: Pinball INFO - passed on from builder —Martijn Boogaarts
|
| | | | (...) not sure what you mean: but - we have 2 chambers, therfore 2 main listners, this made sure the point collector (PC) was able to recieve all the points, and this RCX uses a motor-rotation sensor-rotation sensor construction to transmit the (...) (19 years ago, 7-Nov-05, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Pinball INFO - passed on from builder —Brian Davis
|
| | | | (...) You answered my question very clearly, thank you. This sounds like a nice feedback system using the rotation sensors, and could be used to signal a lot of things. Do you use a single axle connecting two rotation sensors where the axle can be (...) (19 years ago, 7-Nov-05, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Pinball INFO - passed on from builder —Martijn Boogaarts
|
| | | | (...) have a look at the following deep link; (URL) used 2 motors 2 axles and 4 rotation sensors: one set for signals towards the newball RCX and one back towards the Points Collector RCX. (...) Right only one IR message at a time. there is no (...) (19 years ago, 17-Nov-05, to lugnet.robotics)
|
| | | | |
