Subject:
|
Re: Pinball INFO - passed on from builder
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 7 Nov 2005 19:16:13 GMT
|
Viewed:
|
2759 times
|
| |
|
|
In lugnet.robotics, Martijn Boogaarts wrote:
> > I was wondering how you networked between the
> > two IR communication chambers (the article is
> > a little vague, refering to a "direct feedback
> > loop" which could be anything).
>
> not sure what you mean... this RCX uses a
> motor-rotation sensor-rotation sensor construction
> to transmit the points to the newball RCX. this
> one also has a Motor-rotoation-rotation construction
> to feedback the counted points.
You answered my question very clearly, thank you. This sounds like a nice
feedback system using the rotation sensors, and could be used to signal a lot of
things. Do you use a single axle connecting two rotation sensors where the axle
can be turned by either RCX (this would require two motors and two rotation
sensors), or does each RCX have a dedicated output system and a seperate
dedicated input system (this would seem to require two motors and four rotation
sensors).
I assume the RCX collecting the points would not have trouble with
simultaneous IR messages because only one "scoring event" would happen at any
one time (the ball could only hit at most one target or scoring device at a
time). Did the point collecting RCX need to identify where (which RCX) the
points were coming from?
> (I plan to create a little movie so you can see it as well :)
Fantastic - I look forward to seeing it!
--
Brian Davis
|
|
Message has 1 Reply:
 | | Re: Pinball INFO - passed on from builder
|
| (...) have a look at the following deep link; (URL) used 2 motors 2 axles and 4 rotation sensors: one set for signals towards the newball RCX and one back towards the Points Collector RCX. (...) Right only one IR message at a time. there is no (...) (19 years ago, 17-Nov-05, to lugnet.robotics)
|
Message is in Reply To:
| | Re: Pinball INFO - passed on from builder
|
| (...) not sure what you mean: but - we have 2 chambers, therfore 2 main listners, this made sure the point collector (PC) was able to recieve all the points, and this RCX uses a motor-rotation sensor-rotation sensor construction to transmit the (...) (19 years ago, 7-Nov-05, to lugnet.robotics)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
