To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 24284 (-5)
  Re: A LEGO double-throw switch?
 
(...) The following design will turn a polarity switch into a two-way splitter. (URL) That is, the switch controls whether the input will go to the left output or the right. Use two of these, one at each ends of the conveyor belt, to make a (...) (21 years ago, 24-Aug-05, to lugnet.robotics)
 
  Re: A LEGO double-throw switch?
 
(...) I'm here - just amazed at the chaos I kicked up :-). Incidently, I've grown to hate those tank tread belts (those, originally, were going to be the conveyor, but they are just too stiff). I've now got more ideas running around in my head as to (...) (21 years ago, 24-Aug-05, to lugnet.robotics)
 
  Re: A LEGO double-throw switch?
 
(...) Actually, I was working on this very thing (45 degree angles) for a new GBC module over the weekend. (you remember GBC, don't you? You know, the creature that wouldn't die :) - thanks Steve for such a wonderful way to waste all my free time :) (...) (21 years ago, 24-Aug-05, to lugnet.robotics)
 
  Re: Legway (Sensor Type Correction)
 
(...) Absolutely!! I am always interested in seeing unique solutions to the same quest. Sounds like a neat idea. Thanks, Bryan (21 years ago, 24-Aug-05, to lugnet.robotics)
 
  Re: A LEGO double-throw switch?
 
(...) Well, given that technic is quantized down to stud or half stud sizes, the solution may not be obvious. The easiest angles to create are due to 3-4-5 triangles. Most of the bent liftarms are bent based on those angles. The tri-blade liftarms (...) (21 years ago, 24-Aug-05, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR