To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 23479 (-5)
  Re: Smack my MOC! - Fly Mech
 
(...) (22 years ago, 9-Feb-05, to lugnet.robotics)
 
  Re: Sending Commands to Spybot from RCX - Question from a Beginner to Comm area.
 
Hi Everybody, I have used SendSpybotMsg and SendSpybotCtrlMessage (of course in connection with resopective set messages) without any problems using BCC 3.3.7.5 and 3.3.7.9. These two commands gives RCX a nice control over spybot. Specially (...) (22 years ago, 8-Feb-05, to lugnet.robotics.spybotics, lugnet.robotics, lugnet.robotics.rcx, lugnet.robotics.rcx.nqc)
 
  Re: Four rotation sensors on a single sensor port
 
(...) Interesting trick. Thanks for sharing! Philo (22 years ago, 8-Feb-05, to lugnet.robotics)
 
  Four rotation sensors on a single sensor port
 
Hi, that is possible, they count reliably if you move only one at a time and always stop them when their raw-value is the highest (close to 1023, the axis hole is horizontal/vertical). Have fun Jürgen (22 years ago, 8-Feb-05, to lugnet.robotics)
 
  Re: Internals
 
Hi Geoffrey, (...) I know that, but the gears that I mean don't take part in the reduction, the reduction is essentially done only by the axis next to the motor. (...) I was only wondering why they would put two gears on an axis when the second one (...) (22 years ago, 8-Feb-05, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR