 | | Re: The Great Ball Contraption
|
|
Brian Davis writes: > Instead of that, just make sure that your module delivers through > the "side" of the downstream module's territory. Then the spec should say that the ball should go through a vertical plane, and specify the size of the (...) (22 years ago, 10-Jan-05, to lugnet.robotics)
|
| |
 | | Re: The Great Ball Contraption
|
|
(...) Why not universalize the standard so that a module that can turn must be configurable to turn either to the left or the right? A few ways this could be done are movable output stages, EG a sliding or drop-in output that can be placed where (...) (22 years ago, 10-Jan-05, to lugnet.robotics)
|
| |
 | | Re: The Great Ball Contraption
|
|
(...) Actually, it's pretty interesting, if you consider how complex making a pair of turns really is. If you make a 90 degree right hand turn on a 32x32 baseplate, the module must output right next to it's own input. But, bins on a left-hand turn (...) (22 years ago, 10-Jan-05, to lugnet.robotics)
|
| |
 | | Re: The Great Ball Contraption
|
|
(...) Who will promptly tell you to talk to Nik. They're his, not mine. However I CERTAINLY will be advising him to hold out for good space parts in trade. :) I might have to see if we can build one or two of these, seems like good fun. I might even (...) (22 years ago, 10-Jan-05, to lugnet.robotics)
|
| |
 | | Re: The Great Ball Contraption
|
|
(...) I think you can handle this with a little care in the design of the rules. If the table you are setting it up on is deep enough to permit it, you could always use four 90 degree pieces in a LEFT/RIGHT/RIGHT/LEFT sequence to keep the overall (...) (22 years ago, 9-Jan-05, to lugnet.robotics)
|