 | | Re: The Great Ball Contraption —Steve Hassenplug
|
| | | (...) Actually, it's pretty interesting, if you consider how complex making a pair of turns really is. If you make a 90 degree right hand turn on a 32x32 baseplate, the module must output right next to it's own input. But, bins on a left-hand turn (...) (20 years ago, 10-Jan-05, to lugnet.robotics)
|
| | | |
| | | | | Re: The Great Ball Contraption —Geoffrey Hyde
|
| | | | (...) Why not universalize the standard so that a module that can turn must be configurable to turn either to the left or the right? A few ways this could be done are movable output stages, EG a sliding or drop-in output that can be placed where (...) (20 years ago, 10-Jan-05, to lugnet.robotics)
|
| | | | |
| | | | | | Re: The Great Ball Contraption —Steve Hassenplug
|
| | | | (...) Is there something that a module builder can not do because the standard is too simple? Steve (20 years ago, 10-Jan-05, to lugnet.robotics)
|
| | | | |
| | | | | | Re: The Great Ball Contraption —David Koudys
|
| | | | | (...) Not to oversimplify, but I mean if the 'standard' for the ball contraption is 32 studs from the front of the hopper to the back edge of the baseplate, and thus I personally would probably grab a 32 x 32 stud baseplate to build on, thus the (...) (20 years ago, 10-Jan-05, to lugnet.robotics)
|
| | | | | |
| | | | | | | Re: The Great Ball Contraption —
|
| | | | | | news-gateway@lugnet.com wrote on 01/10/2005 10:01:48 AM: (...) thus the (...) module, (...) or 90 (...) That assumes that there is nothing in front of the hopper. There is nothing to say that you are limited to a module 32 studs deep. If you choose (...) (20 years ago, 10-Jan-05, to lugnet.robotics)
|
| | | | | | |
| | | | | | | | Re: The Great Ball Contraption —David Koudys
|
| | | | | | (...) I completely agree with that assessment. However, the premise is that I'm using a 32x32 baseplate with the hopper in the bottom left hand corner--using that premise, the module can be used either in-line, or 90 degrees. If one does not use the (...) (20 years ago, 10-Jan-05, to lugnet.robotics)
|
| | | | | | |
| | | | | | Re: The Great Ball Contraption —Geoffrey Hyde
|
| | | | "Steve Hassenplug" <Steve@TeamHassenplug.org> wrote in message (...) Yes. Currently it's not being able to make turns in both directions with the hopper feed setup the way it is. Someone did point out that there would be a lot of wasted space if (...) (20 years ago, 11-Jan-05, to lugnet.robotics)
|
| | | | |
| | | | | | Re: The Great Ball Contraption —Steve Hassenplug
|
| | | | (...) That's really not true. As a module builder, you can make all the turns you want. This one makes a whole bunch: (URL) you can't figure out how to put the output in the correct place, with respect to the input, that's not a problem with the (...) (20 years ago, 11-Jan-05, to lugnet.robotics)
|
| | | | |
