| |
In lugnet.robotics, Ross Crawford wrote:
> In lugnet.robotics, John Hansen wrote:
> > I have heard from a user of BricxCC who has been experiencing the
> >
> > "compile failed: no (or bad) reply from RCX"
[snip, adjust timeouts]
> >
> > If you have had problems downloading NQC programs using BricxCC with the USB
> > tower you may want to try adjusting these three timeout values. Depending on
> > your PC you may need to use different values than the ones which worked for the
> > user who figured out this issue for me.
>
> See that is what makes Lugnet such a great resource! I finally decided to try
> out Bricxcc/NQC (after using BrickOS on Linux) and it worked fine when I was
> just downloading short "Hello World" programs, but I pretty soon ran into this
> problem and wondered what I'd changed. Typed "reply from rcx" into Lugnet
> search, and Voila! This post comes up at the top, and fixes my problem!
>
> Thanks all!
>
> ROSCO
I'm getting the same error with my Scout and Bricxcc/NQC for downloading programs, the direct control works fine. I found that having fresh batteries helped in getting programs to download successfully. I'll try the timeout adjustment as well
|
|
Message is in Reply To:
6 Messages in This Thread:
 
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
