 | | Re: RCX 2.0 Power Supply
|
| (...) Thanks for pointing that out, Philo. I think I'll stick to the non-hopped up version! :-) (...) Hopefully you didn't find this out the hard way... Mark (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains, FTX)
| | |  | | Re: RCX 2.0 Power Supply
|
| (...) It is nearly impossible to build a power supply that puts out the rated voltage when there is no load. Most will put out too high a voltage (like you have seen), some just shut down. To meassure the voltage of a PS, shorten it with a 1000 Ohm (...) (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)
| | |  | | Re: RCX 2.0 Power Supply
|
| (...) Indeed, the input capacitor of the RCX is rated 10V, so I would not do that for a too long time. This 1000µF capacitor, used to keep memory during battery exchange, is directly connected to RCX board supply input. By the way, this capacitor is (...) (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains, FTX)
| | |  | | Re: Lego Compatible (was Re: JCX and Legos...)
|
| Joe: I was hoping more people would chime in. Alas, I do not see much interest in this thread right now. Please accept my apologies in advance, my comments below are going to sound like an advertisement ... (...) Such a system already exists and it (...) (22 years ago, 15-Sep-04, to lugnet.robotics)
| | |  | | Re: RCX 2.0 Power Supply
|
| (...) You need to check the voltage while the PS is under load. Pretty much every power supply puts out more when the load is low or nothing. Has to do with loads of factors, but mostly quality of the PS (and (thus) internal resistance of the PS) (...) (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)
| |