To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 22624 (-5)
  Re: challenge: LEGO copier
 
(...) OK, just to clarify: assume an X-Y-Z space with studs sticking up in the Z direction. You mean a model that's only one stud thick in X, arbitrarily wide in Y, and arbitrarily high in Z? Yes, that would be a much simpler problem than what I was (...) (22 years ago, 4-Aug-04, to lugnet.robotics)
 
  Re: challenge: LEGO copier
 
(...) The closest I got to something like that was my half-built Duck Assembly Carousel - a dial automation with 4 positions, which would assemble the body (2x1 inverted slope), beak (2x1 plate), and head (1x1 brick with a hole in it). I didn't have (...) (22 years ago, 4-Aug-04, to lugnet.robotics)
 
  Re: challenge: LEGO copier
 
Would the bricks be assembled as a wall one brick thick on its side? Like laying a cinderblock wall on its side then creating a copy? That might be done with an X-Y table arrangement with vice like sides at top and bottom of the bricks so that they (...) (22 years ago, 4-Aug-04, to lugnet.robotics)
 
  Re: challenge: LEGO copier
 
(...) There are some clever tricks (diff & ratchet/clutch, muxes) to expand it somewhat for some applications, but in general, yes, a single RCX can drive only three independent pulse-width modulated polarity reversible 9V outputs. -SMQ Shawn (...) (22 years ago, 4-Aug-04, to lugnet.robotics)
 
  Re: challenge: LEGO copier
 
(...) No, I meant stuck to each other. (...) That's what I had in mind too. (...) I was assuming the use of a camera, not the LEGO light sensor. But using the light sensor is a clever idea. (...) Here I expose my complete cluelessness with regard to (...) (22 years ago, 4-Aug-04, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR