 | | Re: Pneumatics Vs. Hydraulics
|
|
(...) Take two valves, two 2cm tubes with an antenna stuck in the end, a 8cm tube and input and output tubes. Arrange the valves so that they switch together, using "1" joints on their levers, connected by a liftarm (centres 32mm apart for old (...) (22 years ago, 2-Aug-04, to lugnet.robotics)
|
| |
 | | Re: Pneumatics Vs. Hydraulics
|
|
(...) I'm not clear on this. It sounds interesting, I just can't picture how it's done. Where does the tube go? Is it acting like a little variable volume reservoir? (...) I agree completely here. Hydraulics would be *much* more complicated, (...) (22 years ago, 2-Aug-04, to lugnet.robotics)
|
| |
 | | Re: Pneumatics Vs. Hydraulics
|
|
Thank you much! (22 years ago, 27-Jul-04, to lugnet.robotics)
|
| |
 | | Re: Pneumatics Vs. Hydraulics
|
|
(...) One way to change pressure in Lego pneumatics by a small amount is to switch in a short tube (2cm) with an antenna stuck in the end. This lets only a small amount of air out of the cylinder, whilst not exhausting any to the atmosphere. (...) I (...) (22 years ago, 31-Jul-04, to lugnet.robotics)
|
| |
 | | Re: USB Tower
|
|
Hi Alberto, (...) yes, and I take care of the driver as of 2.6.6 . You really don't need the LEGO Software. (If you just want the driver you can get the RCX SDK 2.5.) Jürgen (22 years ago, 30-Jul-04, to lugnet.robotics)
|