Subject:
|
Re: Patched firmware to improve rotation sensor, was Re: Robolab, byte codes and assembler
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 30 Nov 2003 01:36:08 GMT
|
Original-From:
|
Steve Baker <sjbaker1@airmail&spamless&.net>
|
Viewed:
|
1334 times
|
| |
|
|
Don Stauffer wrote:
> > I think RoboLab uses its own firmware, so patching FIRM0328.LGO won't help you
> > unless you use the RIS programming environment. (Or NQC, but that apparently
> > isn't allowed by FIRST?)
>
>
> <snip>
>
> That would be disappointing! I discarded the RIS software very early on.
If FIRST doesn't allow NQC - I can't see it allowing patched RCX firmware.
---------------------------- Steve Baker -------------------------
HomeEmail: <sjbaker1@airmail.net> WorkEmail: <sjbaker@link.com>
HomePage : http://www.sjbaker.org
Projects : http://plib.sf.net http://tuxaqfh.sf.net
http://tuxkart.sf.net http://prettypoly.sf.net
-----BEGIN GEEK CODE BLOCK-----
GCS d-- s:+ a+ C++++$ UL+++$ P--- L++++$ E--- W+++ N o+ K? w--- !O M-
V-- PS++ PE- Y-- PGP-- t+ 5 X R+++ tv b++ DI++ D G+ e++ h--(-) r+++ y++++
-----END GEEK CODE BLOCK-----
|
|
Message is in Reply To:
17 Messages in This Thread:
 
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
