 | | Re: Patched firmware to improve rotation sensor, was Re: Robolab, byte codes and assembler —Philippe Hurbain
| | | | Hello Don, (...) firm0309.lgo is firmware from RIS 1.5, while firm0328.lgo comes from RIS 2.0. Maybe RIS 1.5 can't download 2.0 firmware, never tried that... (...) I suggest you download BricxCC from (URL) and use its download utility (located in (...) (21 years ago, 29-Nov-03, to lugnet.robotics, lugnet.robotics.rcx.robolab)
| | | | | | | | | | Re: Patched firmware to improve rotation sensor, was Re: Robolab, byte codes and assembler —Chris Phillips
| | | | | (...) I think RoboLab uses its own firmware, so patching FIRM0328.LGO won't help you unless you use the RIS programming environment. (Or NQC, but that apparently isn't allowed by FIRST?) (...) I've used FIRM0328.LGO with older (version 1.0) RCXes (...) (21 years ago, 29-Nov-03, to lugnet.robotics, lugnet.robotics.rcx.robolab)
| | | | | | | | | | | | Re: Patched firmware to improve rotation sensor, was Re: Robolab, byte codes and assembler —Don Stauffer
| | | | | (...) <snip> That would be disappointing! I discarded the RIS software very early on. Dick, can you clarify this issue? (21 years ago, 30-Nov-03, to lugnet.robotics, lugnet.robotics.rcx.robolab)
| | | | | | | | | | | | Re: Patched firmware to improve rotation sensor, was Re: Robolab, byte codes and assembler —Steve Baker
| | | | | (...) If FIRST doesn't allow NQC - I can't see it allowing patched RCX firmware. ---...--- Steve Baker ---...--- HomeEmail: <sjbaker1@airmail.net> WorkEmail: <sjbaker@link.com> HomePage : (URL) : (4 URLs) GEEK CODE BLOCK----- GCS d-- s:+ a+ C++++$ (...) (21 years ago, 30-Nov-03, to lugnet.robotics)
| | | | | | |
