 | | Re: Alternate IR Comm Setups
|
|
(...) Dustin, I believe that the built-in IR in a laptop uses a different carrier frequency than the 38KHz used by the RCX 1.0. I've seen reports here that the 2.0 RCX can be reconfigured (with some low-level system programming) to use a 76KHz (...) (23 years ago, 12-Nov-03, to lugnet.robotics)
|
| |
 | | Alternate IR Comm Setups
|
|
Has anyone attempted or had any success using the built-in IR ports on laptops to communicate with the RCX? Dustin (23 years ago, 12-Nov-03, to lugnet.robotics)
|
| |
 | | Re: Homebrew sensors (where to find them)
|
|
(...) I have used Pete's stuff. (URL) (23 years ago, 11-Nov-03, to lugnet.robotics)
|
| |
 | | Re: Memory Map for the RCX
|
|
(...) Here's a brief summary: 0000-3FFF On-chip ROM 4000-7FFF Unused 8000-EFFF External RAM F000-FB7F External RAM, motor control register (write) FB80-FD7F Reserved FD80-FEFF On-chip RAM FF00-FF7F On-chip RAM (can use 8-bit addressing modes) (...) (23 years ago, 11-Nov-03, to lugnet.robotics)
|
| |
 | | Re: Mars Rover
|
|
We also had low battery ... on MARS! We beamed one human being to replace them. Then we had the firmware lost. This was a job only for Scotty. Now all seems to work again for three quarters of an hour. Then everything will be shut down until (...) (23 years ago, 11-Nov-03, to lugnet.robotics)
|