Subject:
|
Re: Pneumatic Magic Presetnation Maertials
|
Newsgroups:
|
lugnet.technic, lugnet.robotics
|
Date:
|
Wed, 27 Aug 2003 16:20:33 GMT
|
Viewed:
|
233 times
|
| |
|
|
"Jennifer Clark" <jen@vulture.dmem.strath.ac.uk> wrote:
[ceramic grease in pneumatic cylinders]
> I've just tried this and it does make a significant improvement, especially
> on older cylinders. With two old cylinders connected up in parallel, I found
> that the treated one would extend and retract before the untreated one, and
> when both were treated both became more or less equal again. I don't suppose
> there is any chance of damage to the seals from this grease?
I hope there's no chance of damage :) I went for ceramic grease over
organic as I understand it's fairly inert. I'm no chemist though and I
don't even know what the seals are made from.
A check of my cylinders (which had this treatment about 18 months ago)
shows they are still holding pressure and in the transparent ones I
can't see any visible degradation of the seals. So far, so good.
Tim
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Pneumatic Magic Presetnation Maertials
|
| "Tim Auton" <tim.lugnet@uton.org> wrote in message (...) I've just tried this and it does make a significant improvement, especially on older cylinders. With two old cylinders connected up in parallel, I found that the treated one would extend and (...) (21 years ago, 27-Aug-03, to lugnet.technic, lugnet.robotics)
|
30 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
