Subject:
|
Re: Error in UBS plotter instructions!
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sat, 9 Aug 2003 17:59:07 GMT
|
Viewed:
|
904 times
|
| |
|
|
In lugnet.robotics, Ramy Fahmy wrote:
> I just got my Ultimate builders set last week and found that the plotter model
> is way too cool. I built it, but the sample program didn't work the way it was
> supposed to. I looked at the program and it had programming for sensor ports 1
> and 2. So I went back to the building instructions on the CD, and to my
> surprise, found an error on step 58 of the final building instructions. It
> shows that the wire lead be attached to the sensor port 3 on the RCX, and it
> should be connected to sensor port 1. I made this simple change and, Voila,
> worked like a charm.
>
> Did anyone else have this problem? Or is it a specific batch of the UBS
> software that has this error?
>
> -Ramy
That sounds familiar but it's been a while. There was definitely some program
like that in the UBS and/or the programs that came with the expert level
challenges in RIS 2.0. I remember having to change a sensor port number (or
change the wiring) to get the program to run. It was no big deal so the exact
model it was for does not come to mind.
|
|
Message is in Reply To:
 | | Error in UBS plotter instructions!
|
| I just got my Ultimate builders set last week and found that the plotter model is way too cool. I built it, but the sample program didn't work the way it was supposed to. I looked at the program and it had programming for sensor ports 1 and 2. So I (...) (21 years ago, 9-Aug-03, to lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
