To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 20004
  Re: IR Tower not working when downloading firmware
 
Andrew J. Huang wrote: > Wendy's problem is (...) The way to figure out which serial port on the back of the PC corresponds to which COM port is to use the world's cheapest piece of test equipment...the lowly paperclip. Bend your paperclip into a U (...) (21 years ago, 11-Jan-03, to lugnet.robotics)
 
  Re: IR Tower not working when downloading firmware
 
(...) Which physical pins are 2 and 3? I assume they would be the Tx and Rx pins, but I don't know where they are. Pretty cool - data going through a paperclip. (21 years ago, 11-Jan-03, to lugnet.robotics)
 
  Re: IR Tower not working when downloading firmware
 
(...) For a female connector: 5 4 3 2 1 * * * * * * * * * 9 8 7 6 For a male connector: 1 2 3 4 5 * * * * * * * * * 6 7 8 9 (The 'male' is the one with the pins - the 'female' is the one with the holes) (...) Yes - I have some good Geek stories (...) (21 years ago, 11-Jan-03, to lugnet.robotics)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR