 | | Re: Use RCX motor output to switch devices —Remko Roodselaar
|
| | | In response to the following, Ran Talbot e-mailed me. (...) "A "full-wave bridge rectifier" (as used in AC-to-DC power supplies) will do that nicely. I believe some of the Lego "active" sensors do this. I don't know if anyone makes an AC (...) (22 years ago, 8-Sep-02, to lugnet.robotics)
|
| | | |
| | | | | Re: Use RCX motor output to switch devices —Remko Roodselaar
|
| | | | Also, in the meantime I have built quite an attractive solution using a small relay, that has been built into a Lego 'mailbox'. I will post a little tutorial on my site on building it, because I am rather charmed by the simplicity and robustness of (...) (22 years ago, 8-Sep-02, to lugnet.robotics)
|
| | | | |
| | | | | | Tutorial: use RCX motor output to switch devices / build your own interface —Remko Roodselaar
|
| | | | (...) I hope this tutorial will give you some good ideas of your own too! It can be found here: (URL) please e-mail me with your comments or mistakes in the tutorial, or post it here. Have fun, Remko (22 years ago, 11-Sep-02, to lugnet.robotics)
|
| | | | |
