 | | R/C Servo to Legos —John Kittelsrud
|
| | | Does anyone have a solution for coupling the output of an R/C servo to something like a Lego axel? Thanks. (26 years ago, 27-Dec-98, to lugnet.robotics)
|
| | | |
| | | | | Re: R/C Servo to Legos —Colin A. Reed
|
| | | | | You could glue a lego gear onto the servo horn and axles into that. (...) (26 years ago, 27-Dec-98, to lugnet.robotics)
|
| | | | | |
| | | | | Re: R/C Servo to Legos —Russell Nelson
|
| | | | | John Kittelsrud writes: > Does anyone have a solution for coupling the output of an R/C servo > to something like a Lego axel? I did it using an axle stopper glued on with hot-melt glue. Worked fine until I would over-torque it. (26 years ago, 27-Dec-98, to lugnet.robotics)
|
| | | | | |
| | | | | Re: R/C Servo to Legos —John Scharles
|
| | | | (...) something like a (...) The usual way the RC community does it is to use a cover from a auto tire valve stem, fill it with epoxy and push it over the splines of the output shaft. Be careful that no epoxy runs down into the bearing of shaft :-). (...) (26 years ago, 27-Dec-98, to lugnet.robotics)
|
| | | | |
