| |
Beautiful! I saw that page on parallemic as well... Looks like you did a
good job making the lego version! I liked the multiple worm gear setup you
used to take up the backlash. Just a couple of questions... What are the
crossed rubber bands for? Do they help to take up the slack in the joints?
Also, what are you cutting??? Is that processed cheese??? As always, very
impressive.
Rob
In lugnet.technic, Robert Fay writes:
> I have posted some pictures and a movie of my attempt to build a working
> OrthoGlide Mill. I was only moderately successful. I have cut candles,
> toast, sidewalk chalk and now the ........ Well, you will see!
> http://www.ozbricks.com/bobfay/orthogli.htm
>
>
> --
> Bob Fay
>
> THE SHOP
> http://www.ozbricks.com/bobfay
|
|
Message has 1 Reply:
 | | Re: An OrthoGlide Mill
|
| Thanks for your comments Rob. The crossed rubber belts are a last ditch attempt to remove the backlash from the joints. The use of friction pins caused the joints to become so stiff that the platform would not follow the action of the arms. I found (...) (23 years ago, 7-May-02, to lugnet.technic, lugnet.robotics)
|
Message is in Reply To:
| | An OrthoGlide Mill
|
| I have posted some pictures and a movie of my attempt to build a working OrthoGlide Mill. I was only moderately successful. I have cut candles, toast, sidewalk chalk and now the ........ Well, you will see! (URL) Fay THE SHOP (URL) (23 years ago, 6-May-02, to lugnet.technic, lugnet.robotics)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
