To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 17550
17549  |  17551
Subject: 
Re: is it possible to use a polarity switch with a RCX input?
Newsgroups: 
lugnet.robotics, lugnet.robotics.rcx
Date: 
Mon, 25 Mar 2002 16:11:52 GMT
Viewed: 
3509 times
  
In lugnet.robotics, Jerry Kalpin writes:
> In lugnet.robotics, Steven Nickle writes:
> > In lugnet.robotics, Jonathan Wilson writes:
> > > Basicly, what I want is a button, switch or whatever on my model that
> > > when moved one way causes one input to be sent to the RCX but when moved
> > > differently it causes a different input to be sent to the RCX. Should
> > > also have a 3rd "off" state.
> > > I am going to use it on my RCX controlled tank. RCX will use 2 touch
> > > sensors plus 1 motor to drive treads forward or back, touch sensors will
> > > trigger if it bumps into something.
> > > The "switch" I need will controll second motor attached to a large
> > > turntable to rotate turret.
> > 
> > Use a resistor to make one of the states of the switch read less than a full
> > short.  Setup as a light sensor.  0 means off  50~ means one state and 100
> > means another.
> > 
> > This is the basis for alot of the touch sensor multipliers.  I am sure if
> > you dig around you can find the right values.  I don't have any my books handy.
> 
> But... be aware that the 'polarity switch' has only two connectors (for two
> sets of wires).  It's not a '3-way' where you can try to select one of two
> inputs by moving the lever.  The action is forward-off-reverse with one
> power source connected to one motor.
> 
> Jerry


Well the polarity switch can be made to work as a "switcher" that can be
used to can input source or output source by wiring it like Hao-yang Wang
did in this example: http://www.brickshelf.com/cgi-bin/gallery.cgi?f=214

It works great like this, I use it with my RailRacers
(http://www.railracers.com) control system.

jt

------------------
James J. Trobaugh
North Georgia LEGO Train Club
http://www.ngltc.org



Message is in Reply To:
  Re: is it possible to use a polarity switch with a RCX input?
 
(...) But... be aware that the 'polarity switch' has only two connectors (for two sets of wires). It's not a '3-way' where you can try to select one of two inputs by moving the lever. The action is forward-off-reverse with one power source connected (...) (25 years ago, 25-Mar-02, to lugnet.robotics, lugnet.robotics.rcx)

6 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR