Subject:
|
Re: Injection-Molding Factory
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 14 Dec 2001 22:19:20 GMT
|
Viewed:
|
703 times
|
| |
|
|
Great job! The fiber optics are just super in the movie.
--
Bob Fay
THE SHOP
http://www.ozbricks.com/bobfay
"Jerry Kalpin" <jdkalpin@sympatico.ca> wrote in message
news:GoCoIG.L0o@lugnet.com...
> My 0.00000250 Ton LEGO Injection-Molding Factory can be seen at
> http://www3.sympatico.ca/jdkalpin. Navigate to the section: "Inj. • Molding
> Factory".
>
> It consists of a Mold Press, with a motorized screw, barrel heaters, a
> pneumatic ram; also a 4-cavity mold with a manifold heater (for 4mm
> photographic film spools); also an air-compressor set controlled by a
> pressure switch; finally, a motorized valve that causes the mold-press to
> cycle. The RCX is a Motor-Control Center! It is built into a 36 x 36
> (stud) bay. There is a Mold Setup Operator there to give you a sense of
> scale. These can be big machines!
>
> I should tell you that, with 6 AA batteries, the plastic will melt only in
> your imagination. So I don't feel too bad about the absence of the
> 'stripper-plate' for part removal...
>
> Jerry
|
|
Message is in Reply To:
 | | Injection-Molding Factory
|
| My 0.00000250 Ton LEGO Injection-Molding Factory can be seen at (URL) Navigate to the section: "Inj. Molding Factory". It consists of a Mold Press, with a motorized screw, barrel heaters, a pneumatic ram; also a 4-cavity mold with a manifold heater (...) (23 years ago, 14-Dec-01, to lugnet.robotics)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
