To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 16717
    Re: Electro-magnets
   What is your plan for the electromagnets? If you can not find them, they are simple to make yourself out of fine insulated (varnished) copper wire. You will have to do a little bit of experimenting to get the streingth just right. Wrap the wire into (...) (23 years ago, 11-Dec-01, to lugnet.robotics)
   
        Re: Electro-magnets —Rainer Balzerowski
     IMHO is the easiest way to get strong electro-magnets to disassemble 6V relays. They include good electro-magnets. I did so and was able to hold a 500g hammer with two of them running at 6V. I used relays from FINDER (Series 55 if i remember right), (...) (23 years ago, 11-Dec-01, to lugnet.robotics)
    
         Re: Electro-magnets —Pete Sevcik
     Another simple source is a 12 volt electro-magnetic clutch. These are available on the surplus market, with typical price around $5 US. - pete. (...) (23 years ago, 12-Dec-01, to lugnet.robotics)
   
        Re: Electro-magnets —Ben Firshman
   In message <145.625b6f1.2947e682@aol.com>, Styxrocks@aol.com writes (...) I was going to experiment with electromagnet cranes, like the ones you see at junk yards. I will try your suggestion (when I've finished my current project). I will also try (...) (23 years ago, 12-Dec-01, to lugnet.robotics)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR