| |
On Mon, 26 Nov 2001 14:55:19 GMT, "John Barnes" <barnes@sensors.com>
wrote:
> I have two prototype/preproduction "devices" looking for a good home.
>
> 1. Generic RCX sensor adapter brick. This little 2x4 brick interfaces
> between the RCX sensor input and your own sensor design. It does all the
> hardwork, multiplexing the power and sensor input. It provides a stabilized
> 5v @ 10mA output and accepts either a 0 - 5v or 0 - 0.5v input signal. It
> uses a constant current signal to the RCX so it can be relied upon to be
> very accurate. 0 - 5v (or 0 - 0.5v in x10 mode) is scaled to be 0 - 100
> light sensor units at the RCX input.
>
> 2. New variant of the popular 4x6 brick 4 channel radio control receiver.
> This one has proportional speed control of the 4 motor channels. You will
> need an 8 button 418MHz transmitter to be able to use this (CMD-HHTX-418
> from Digikey or RF1046 from HiTechnicStuff).
>
> As per usual, these devices are available at no charge to a suitable "good
> home".
>
> JB
Hi: I would like to be a tester. My email address is
joev@frontiernet.net
|
|
Message is in Reply To:
 | | Testers/Evaluators wanted
|
| I have two prototype/preproduction "devices" looking for a good home. 1. Generic RCX sensor adapter brick. This little 2x4 brick interfaces between the RCX sensor input and your own sensor design. It does all the hardwork, multiplexing the power and (...) (23 years ago, 26-Nov-01, to lugnet.technic, lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
