 | | Re: Power inlet to RCX 1.5? —Juergen Stuber
| | | | (...) I'd use a 9V 1.5A _regulated_ power supply. Lower ampere ratings should also work until you stall three motors ... Jürgen (23 years ago, 24-Aug-01, to lugnet.robotics)
| | | | | | | | | | Re: Power inlet to RCX 1.5? —Remko Roodselaar
| | | | | | (...) Thanks, Jürgen! I have installed the firmware with a 9.6V=, 50mA! adapter, but no sensors or motors connected :-) It was a breeze after I found the right connection plates inside the battery bay. Gr., Remko (23 years ago, 24-Aug-01, to lugnet.robotics)
| | | | | | | | | | | | Re: Power inlet to RCX 1.5? —
| | | | | (...) RCX, (...) Coz, (...) to (...) Thanks, Jürgen! I have installed the firmware with a 9.6V=, 50mA! adapter, but no sensors or motors connected :-) It was a breeze after I found the right connection plates inside the battery bay. Gr., Remko (23 years ago, 25-Aug-01, to lugnet.robotics)
| | | | | | |
