Subject:
|
ROBOLAB problem.
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 15 May 2001 15:12:50 GMT
|
Viewed:
|
561 times
|
| |
|
|
Hi
I'm wondering if anybody has seen the following using Robolab v2.?. My son
has a program wherethe first thing he does is backup for 50/100's of a
second(reverse motors B&C)turn for 25/100's of a second (motor B forward) and
then backup for another50/100's of a second (reverse motor B again). The first
time the program isrun after a download the RCX backs up about 15cm makes about
a 90 degree turnand backs up another 4 cm. However each subsequent time the
program is run it backs up about 5 cm makes a 45 degree turn and backs up
anothe 1-2 cm.
The initial behavior was what we wanted, and the timing was arrived at by trial
and error. Does anybody know what is happening here?
As I type this I started to think about those times and realize that the second
and subsequent runs are probably the ones that are behaving properly, but we
still need a way of getting all of the runs to behave consistently.
thanks
gord u
|
|
Message has 1 Reply:
2 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
