Subject:
|
Programming Scout
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 7 May 2001 02:42:37 GMT
|
Original-From:
|
Niels Holme <holme@^StopSpam^eecs.umich.edu>
|
Viewed:
|
702 times
|
| |
|
|
I have been looking for some information on how to program the Scout
Brick, does anybody have a link to a good starting point, I got the
Scout SDK from lego's website, but are there any alternatives around
out there for the scout?
For a start I would like to make a simple program that would allow
me to control the motor output on the scout from the RCX without
having to resend commands from the rcx every 1/2 second. This I
think I should be able to do, by overwriting
the default action caused by a message event. It might also be cool
if I could get the touch sensors on the Scout to cause messages to
be send back to the RCX, any suggestions ?
Thanks
Christian Holme
|
|
Message has 1 Reply:
 | | Re: Programming Scout
|
| (...) You can program the Scout using Not Quite C. There is a command line flag to set the target to the Scout. There is also a new version of the RCX Command Center from John Hansen that works pretty well. Using it you can program the scout, or (...) (24 years ago, 7-May-01, to lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
