 | | Re: Length of Diagonal Spreadsheet
|
|
(...) Er oops :) that's a 2L spacing, same as 24T to 8T or 16T to 16T. (24 years ago, 8-Apr-01, to lugnet.robotics)
|
| |
| | Re: A couple of questions
|
|
(...) Only by the vocal majority, I think. There has been a recent thread about a sub-group (cult?) of "grinders". I say the end justifies the means here. You might look into FischerTechnik (my spelling may be off). Someone on this newsgroup did (...) (24 years ago, 8-Apr-01, to lugnet.robotics)
|
| |
| | Re: Length of Diagonal Spreadsheet
|
|
(...) ---...--- snip ---...--- (...) Gus I can't download the sheet nor can I open it online. If you can email it to me I can convert and return the pdf via email, providing the document isn't too large for your mail box. Dave (24 years ago, 7-Apr-01, to lugnet.robotics)
|
| |
| | Re: Length of Diagonal Spreadsheet
|
|
(...) Thanks for the link to your gear spacing site. That is sort of what I was looking for though in my chart I aimed at being more general then just a list of workable gear spacing. My diagonal measurements can also be used to find workable beam (...) (24 years ago, 8-Apr-01, to lugnet.robotics)
|
| |
| | Re: Length of Diagonal Spreadsheet (Now in PDF format!)
|
|
Thank you everyone who either offered to make a PDF file or went ahead and made one and mailed it to me. Here is the PDF version of the spreadsheet. (URL) suggest that you print it out and try out some of the diagonals. For the new 12 and 20 tooth (...) (24 years ago, 8-Apr-01, to lugnet.org.us.smart, lugnet.robotics, lugnet.technic)
|
