 | | Re: NQC for Palm
|
|
<snip> it's too bad that all of you just HAVE to use a palm OS device. someone a long time ago ported nqc to windowsce and it works fine, i'm able to do on the fly programming and uploading with a first generation device, which i'm actually unhappy (...) (24 years ago, 4-Apr-01, to lugnet.robotics)
|
| |
| | Re: Lubricating technic turntables
|
|
<snip> from using different types of yoyos and other things i have found that the best for inert lubricating is silicon lubricant, there are also some other lubes for nylon that i can't think of but i do know that they are out there. some vcr repair (...) (24 years ago, 4-Apr-01, to lugnet.robotics)
|
| |
| | Re: I wish Lego made an "Anti-Backlash Gear"
|
|
(24 years ago, 4-Apr-01, to lugnet.robotics)
|
| |
| | Re: How about ideas for new elements?
|
|
I would like to try using threaded nylon rods. Where can you buy them? I've only used steel threaded rods to restrain large axial forces (e.g. in a crane turntable). I've also used smooth 3/16" bar stock when I needed a very stiff and strong axle (I (...) (24 years ago, 4-Apr-01, to lugnet.robotics)
|
| |
| | Re: Scout Commands
|
|
(...) If you use NQC then you can write a small program and load it into the Scout...then it behaves much like the RCX. The Scout has VERY little free memory - but it's enough to allow it to act as a dumb peripheral, turning motors on and off and (...) (24 years ago, 4-Apr-01, to lugnet.robotics)
|
