 | | Re: NQC for Palm
|
|
(...) Of course on my Agenda Palmtop - it took little more than typing 'make' to port it. <smug grin> (...) So the Palm is big-endian? I didn't know that. Won't that also cause problems for NQC porting...does NQC run on any other big-endian (...) (24 years ago, 4-Apr-01, to lugnet.robotics)
|
| |
| | Re: I wish Lego made an "Anti-Backlash Gear"
|
|
The CD-Rom does not explaiin how to use this piece, but in an earlier post I wrote: Ok, this is called a "Slip Gear" or "Torque Gear" It is used to prevent over rotation by means of an internal clutch, the 2.5 - 5.0 NCM I belive means the range of (...) (24 years ago, 4-Apr-01, to lugnet.robotics)
|
| |
| | Re: I wish Lego made an "Anti-Backlash Gear"
|
|
(...) Far as I can tell, these are the gears used in the gearboxes in 8880, 8448, 8480, and prob'ly others. ROSCO (24 years ago, 4-Apr-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Lubricating technic turntables
|
|
You got me pegged, it's a purism thing, I pride myself on never cutting or altering pieces, glueing or lubricating. Just work those pieces and they'll loosen up! Get'em... GRRRRR....Eric (...) (24 years ago, 4-Apr-01, to lugnet.robotics)
|
| |
| | Re: Lubricating technic turntables
|
|
(...) That's okay, I'm a purist too. I once spent several frustrating hours completely redesigning the drivetrain on one of my robots so I wouldn't have to trim down four 8L cross axles to 7L. However, when you consider lubricating a turntable (...) (24 years ago, 4-Apr-01, to lugnet.robotics)
|
