 | | Re: Shutting off illumination LED on Light Sensor for LIDAR
|
|
(...) I strongly suspect this is a myth. A transistor is a transistor is a transistor. They all require biasing in order to function properly and that requires power. Mind you, even so-called passive devices must either generate a voltage or have a (...) (24 years ago, 31-Mar-01, to lugnet.robotics)
|
| |
| | Re: Shutting off illumination LED on Light Sensor for LIDAR
|
|
(...) Actually you don't need LegOS, any input set to raw mode with the LEGO firmware will do fine. This is because even in passive mode there is a pull up of 10k to 5V, and in fact the LED is glowing dimly in this mode. Just tried it, I can get raw (...) (24 years ago, 1-Apr-01, to lugnet.robotics)
|
| |
| | Re: Shutting off illumination LED on Light Sensor for LIDAR
|
|
(...) Yes, this is the result I discovered this weekend. My conclusion is that setting the sensor to raw mode does not fully remove the light produced by the LED, and detrimentally impacts the sensor performance. I think my next approach is to try (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
